|
ked
|
 |
« on: November 27, 2011, 09:22:02 am » |
|
1/2 round bar 18-24" long, 2 large washers and two links of chain. weld one washer 1-2" below the top, slide link of chain over top of bar weld next washer on top. drive into the ground until bottom washer is flush. Make sure chain link is large enough to spin. Bull snap on each end of chain (I prefer 8-10 foot) snap one end to the chain the other to your dog. (I have also connect chain to link with an S hook)
You can also take a concrete block (even a half) take your dog chain and hook it bak to itself on one end with an S hook (just like a hondo in a rope) run that through the hole in the block then take the other end of chain through the loop so chain is fastened to the block. Bury the block 6-12 inches in the ground. No tangling, no pulling out, works really good.
|
|
|
|
|
Logged
|
|
|
|
|
