|
Hogsnatchers
|
 |
« on: August 30, 2012, 09:19:08 am » |
|
There are a couple different ways the quickest takes two people. Get one to sit in the truck and pump the clutch and hold it crammed to the floor do not let it up. When they are holding it to the floor crack open the bleeder screw on the slave cylinder at the trans. Be sure you have glasses on and stay out of the way cause its gonna shoot fluid out. Tighten the bleeder back and then repeat the process. Check the fluid after every bleed. If the person in the truck let's the clutch up while the bleeder is open it will pull more air in the system. If the fluid level gets low it will put more air in the system. This is the fastest most efficient way because you push the air out under pressure. You can opt to just crack the bleeder open and let it gravity bleed without pushing the clutch but it takes a while and may still leave a little air
Sent from my ADR6425LVW using Tapatalk 2
|
|
|
|
|
Logged
|
|
|
|
|
