|
Semmes
|
 |
« Reply #20 on: December 05, 2015, 03:04:23 pm » |
|
I cut and drilled out the center off mine then bored out a bigger hole bout 3/4" deep around the mouth end.
It sounds pretty good...
Been sanding on it, it pretty doggone smooth considering what I started with.
Being a goat horn it's got a good random type ridge rib that runs along one side. The horn is obviously thicker there but I like the ridge and am gonna keep it just smooth it up a bit.
I started with hundred grit and worked thru to 30 micron then steel wooled it and its shines good. It could pass now with a coat of oil bit I decided to go back to hundred and get it a little thinner. Just hard to tell when to stop lol
|
|
|
|
|
Logged
|
|
|
|
|
